By Damion Tyrell, Technology Corporate Electric
A Toronto garage in 2026 is rarely just parking. It is a workshop, a charger bay, a gym, sometimes a future coach house — and its electrical usually dates from when it only had to run one bulb and a door opener. Proper garage electrical installation Toronto work starts with a subpanel decision, because nearly every modern garage load flows from that one choice. Technology Corporate Electric wires detached and attached garages across Toronto and the GTA.
Why a subpanel is the foundation
Running one circuit at a time from the house panel — one for the charger, one for the heater, one for the compressor — turns into a trench reopened three times and a house panel full of long home runs. A properly sized feeder to a garage subpanel, commonly 60 to 100 amps, lands once, protects correctly, and leaves breaker space for the load you have not bought yet.
Detached garages need correct underground or overhead feeders, proper burial depth and warning tape for trenches, and grounding done to code at both ends as the Ontario Electrical Safety Code directs. Attached garages are simpler but still benefit: a subpanel beside the workbench beats a trip inside for every tripped breaker. If the house service itself is maxed out, the garage project may start with panel upgrade services in Toronto at the main panel.
EV charging, welders, and the big loads
A Level 2 charger is the load that starts most garage projects. Dedicated circuit, correct breaker and conductor sizing, and load-management options where the house service is tight — details covered on our page for EV charger installation in Toronto. Chargers also change garage habits: cable routing, bollard or wall protection in tight bays, and receptacle placement for a second vehicle later.
Welders and compressors bring their own requirements: 240-volt receptacles matched to the plug configuration, inrush that cheap breakers resent, and receptacle placement planned around the bench, not the door. List the equipment honestly at the quote stage — a 50-amp welder outlet discovered after drywall costs triple.
Our electrical service areas in the GTA page covers the garage-heavy neighbourhoods we serve from Etobicoke to Ajax.
Heat, light, and everyday circuits
Unheated garages eat tools and batteries. A dedicated circuit for a unit heater or baseboards, sized as fixed heating, makes a workshop usable in February. Lighting deserves the same planning: bright, shadow-free LED fixtures over the bench, motion-activated exterior light, and general receptacles — GFCI-protected as garages require — spaced for chargers, block heaters, and pressure washers. Keep one receptacle near the door at a height a snowblower cord appreciates.
Permits and inspection
Garage feeders, subpanels, and new circuits in Ontario require an ESA notification and inspection, and trenching work must be located before digging — call before you dig for utility locates. Reference material lives at the Electrical Safety Authority, esasafe.com.
The standards here mirror our commercial auto-shop and industrial maintenance-bay work: residential, commercial and industrial garages all need feeders that are sized honestly and terminations that stay tight.
Frequently asked questions
How big should my garage subpanel be? An EV charger plus workshop usually lands at 60 amps minimum; add a heater or serious welder and 100 amps earns its cost. The load calculation decides, not a guess.
Can I trench the feeder myself? Homeowners sometimes dig to save money — discuss depth, conduit, and inspection hold points with your electrician first, and never skip locates.
Does a garage subpanel help a future coach house? It can, if sized and placed with that future in mind. Say so at planning time; future-proofing is cheap exactly once.
Power the garage you actually use
Get a feeder and load plan before you buy the charger or welder — contact a Toronto electrician for garage electrical for a site visit.
Technology Corporate Electric — residential, commercial and industrial electrical services across Toronto and the GTA. Call 437-435-7053.